1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Pstwo V15 Black Screen

Discussion in 'PS2 - Hardware boot discussion' started by evo7gsr, Jul 14, 2007.

  1. evo7gsr

    evo7gsr Member

    Joined:
    Jul 14, 2007
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    Hi,

    I recently modded my pstwo V15 SCPH77003 with a matrix infinity green dot chip and now when i turn on the ps2 all it does is stays on a black screen. (my monitor doesnt receive any signal). when i turn it on, it powers up normally then after a few seconds powers down into kind of a low power state which it stays there forever and does nothing. the lase also makes a noise twice as if its trying to read but then does nothing.

    Please can someone help.

    Thanks.
     
  2. lilg_06

    lilg_06 Regular member

    Joined:
    Aug 5, 2006
    Messages:
    1,106
    Likes Received:
    0
    Trophy Points:
    46
    Ok, first things first, you need to check all solder connections and make sure they are all secure, and you have not left any dry joints, dry joints also known as cold joints are wires your have soldered that are not really in contact well enough or not at all, so you need to double check. You also need to make sure that you did not bridge any connections when installing the mod chip.
     

Share This Page