1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

R200? Will it print to the edge of the cd and farther in....

Discussion in 'DVD±R media' started by videoJ, Dec 19, 2004.

  1. videoJ

    videoJ Guest

    Just got an R200. Love it so far. The disc I have now though it leaves a small ring on the outside of the disc. I was wondering if anybody knew a work around for this or is there a certain disc type that works with it.
    Also was wondering if it would print those disk that go all the way to the inner ring? I do not see a selection for it in the software.
    Has anyone tried printing with this printer from another program? Is that possible?

    Thank yu in advance for any help. I'm going to search the web some more looking for answers. I saw the r200 post here but it didn't deal with this.

    Thanks again!

    videoJ
     
  2. videoJ

    videoJ Guest

    Just found my answer. Thanks all
     
  3. bbmayo

    bbmayo Active member

    Joined:
    Oct 31, 2004
    Messages:
    5,088
    Likes Received:
    0
    Trophy Points:
    96
    Just in case someone else reads this and is wondering.

    Open Epson Print CD Software
    Go to File
    Go to Inner/outter Diameter Settings
    Then put it on custom and adjust for your DVD
    I use 24mm inner
    and 118mm outer for my Prodisc x8

     
    Last edited: Dec 19, 2004
  4. bravo6

    bravo6 Member

    Joined:
    Oct 28, 2004
    Messages:
    12
    Likes Received:
    0
    Trophy Points:
    11
    Mine is printing off center, to the right just a little bit. When I cahnge the print settings and shift it, it doesn't seem to move at all.

    Any ideas?
     

Share This Page