1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RIBBON WIRES

Discussion in 'PS2 - Hardware boot discussion' started by sheaman, Dec 27, 2004.

  1. sheaman

    sheaman Member

    Joined:
    Dec 27, 2004
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    I HAD RECENTLY FIXED MY PS2 AND I FOUND THAT WHILE I FIXED IT THE CORED FOR THE CONTROLLER PORT FELL OUT. NOT ONLY THAT BUT ALSO THE BROWN CORD THAT CONNECTS TO THE LASER ALSO FELL OUT. THESE CORDS FALL OUT AFTER I PUT THEM IN AND I CANT KEEP THEM IN. IS THERE A SECRET AS HOW TO DO IT?
     
  2. Ag3ntNe0

    Ag3ntNe0 Guest

    I recently put a ps2 together after it had been completely taken apart. All the ribbon cables and wires were disconnected. In the slots where you put in certain ribbon cables you can lift up a flap that is not really noticable. Once that flap is lifted you can slide in the ribbon cable. Some slots dont have the flap so you have to make sure you are pushing it into the correct place. And pull the ribbon cable slightly to make sure it is in there good before you put the ps2 back together. Hope this helps.
     

Share This Page