1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Setting up FULL Stereo

Discussion in 'Audio' started by eXpose, Jul 18, 2003.

  1. eXpose

    eXpose Member

    Joined:
    Jul 18, 2003
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    Hi, all!
    I'm a bit new with Lame, but i read a lot of stuff on forums and guides. However I still couldn't figure out where to set the Options to FULL Stereo. As a Front-end of Lame 3.93 i'm using the RazorLame 1.1.5 and i didn't find anything there either. All i saw was: Stereo, Joint Stereo, Forced Joint Stereo, Mono, Default.

    Plz help, thx.
     
  2. tigre

    tigre Moderator Staff Member

    Joined:
    Feb 18, 2003
    Messages:
    789
    Likes Received:
    0
    Trophy Points:
    26
    You might want to read this thread:
    http://forums.afterdawn.com/thread_view.cfm/1912

    "True stereo" is Left-Right, if you use Joint stereo Lame decides where to use Left-Right and where Middle-Side. Lame does a very good job with this, so using "True stereo" always results in inferiour quality (takling about Lame 3.90 and newer) because it wastes bits that could be used for really important things.

    So use --alt-preset standard without messing with other settings, if you think you need even better quality use --alt-preset insane.
     

Share This Page