1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Should I use this glue gun?

Discussion in 'PS2 - Hardware boot discussion' started by Rolling_S, Jan 7, 2007.

  1. Rolling_S

    Rolling_S Member

    Joined:
    Jan 7, 2007
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    11
    http://www.acehardware.com/product/...7&cp&kw=2090694

    I plan to install a DMS4 into my PS2, but I brought a glue gun from Ace earlier today and realized it only has a high setting. So my question is it safe to use this gun or should I buy one with a low heat setting? I read on Wiki high temp guns heat to 380F which to me seems a bit much for a PS2 motherboard. I hope Ace will let me return it if I have to especially since I haven't opened it.
     
  2. Rolling_S

    Rolling_S Member

    Joined:
    Jan 7, 2007
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    11
    I Can't find an edit button so here is the working link.
     
  3. dreamzboy

    dreamzboy Regular member

    Joined:
    Jul 14, 2005
    Messages:
    168
    Likes Received:
    0
    Trophy Points:
    26
    I don't think it matters, cuz the moment you melt the glue on the board, it will cool down a lot. I don't recommend using it as though you'll have a lot harder time trying to remove the glue if you mess something up. Electrical tape or clear tape is just as good.
     
  4. Rolling_S

    Rolling_S Member

    Joined:
    Jan 7, 2007
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    11
    Thanks.
     

Share This Page