1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SM 3.6 DVD Won't Boot

Discussion in 'PS2 - Software boot discussion' started by Slynth, Jul 7, 2007.

  1. Slynth

    Slynth Member

    Joined:
    Jul 7, 2007
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    11
    OK, I finished my Magic Keys II install on my PS2, and it worked. When I place the CD SM 3.6, it works fine. However, when I put my DVD in, it doesn't boot and goes to the PS2's browse screen, where you can select memory cards and the disc. It shows the disc, and the memory card, but... I can't boot it from here either. Upon looking at the bottom of my disc, there seem to be a lot of scuffs (not the individual rings) all over it. Do I have a dud?
     
  2. OmriSama

    OmriSama Regular member

    Joined:
    Apr 6, 2007
    Messages:
    1,154
    Likes Received:
    0
    Trophy Points:
    46
    Alot of slim PS2s have problems reading Swap Magic discs.
    Your disc should have little lines all around the middle and it should be pressed.
     
  3. Slynth

    Slynth Member

    Joined:
    Jul 7, 2007
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    11
    I know that, but there's a lot of scuffs all up and down as well, as if someone placed it on the floor and scratched it up majorly. There's at least 50 scuff marks that are about 1-2mm across. Compared to my CD version, it looks like it was heavily scratched :-/
     

Share This Page