1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SONY DB940 - Protector mode

Discussion in 'Audio' started by KeyEll, Mar 9, 2012.

  1. KeyEll

    KeyEll Member

    Joined:
    Mar 9, 2012
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    I have a problem with SONY
    I have Riciver DB940 and it is stuck in a state of protector mode.
    Soldering iron
    It's still on the state protection.
    I tried to check in and found the problem.
    Maybe someone has a recommendation what should I do?
    Or any part of special notice and check??
    That I had two weeks trying to fix it!

    The problem came when a friend turned up the volume and prepare highest since this is so.
    Currently the speakers are not connected and yet he appears with this message. (Volume has been low!)
     
  2. Mez

    Mez Active member

    Joined:
    Aug 12, 2005
    Messages:
    2,895
    Likes Received:
    9
    Trophy Points:
    68
    You might have fried something or the protector mode may be like a circuit breaker and the circuit is broken. Turning the volume way up was a bad idea. Just because the speakers were not attached doesn't mean you can't blow your amp.
     

Share This Page