When you press Bin File you should get a pop up box to browse and locate the 4.00 firmware you downloaded
i do get that,The box pops up when when i go to find the ptrogramme its nowwhere to be found.I have it saved in a starview folder-the folder opens up but no gtrom in side. When im at my desktop(and not in gtrom) i can open the folder and see/open the gtrom but like i said it wont open up in Bin File?? A nightmare!
hi ive just got THE BOX over the internet but cant get to the nagravision, have a starview in my bedroom but pressing 1570 isnt working, can any1 help please?
Updating Firmware Connect your box and PC with a Null modem cable and switch on the cable box and put it on STANDBY. (The Starvi*w does not need to be connected to TV to update it with GTROM) Open GTROM Loader software make sure that you set the correct COM PORT that matches the one that is being used Make sure App file only is selected, then click Bin File & browse to the firmware where you downloaded it to on your PC. Run the GTROM loader by pressing Download and you will see the % progress increase then Download completed message on your PC. Wait until you see the DOWNLOAD COMPLETE pop up on your PC before removing the NULL MODEM CABLE. The Starvi*w will then reboot Disconnect from PC and connect back up to the TV
Ok some b0xes that come with 4.54 installed are missing the logo file You will need to update the b0x with a NULL MODEM CABLE You will need version 4.50 IRELAND firmware for THE B0X found in "THE B0X" firmware folder. You will need version 4.51 UK firmware for THE B0X found in "THE B0X" firmware folder.
if your box comes with the v4.54e on it you do not have to load the logo file all you need to do is put the v4.54e_E on it only earlier versions of this you have to put the logo file on i will upload the v4.54e_E to the eko site now if you want to get it you do of course need to use the new loader to load the firmware which i will also upload when you have the firmware on your box you will have to rescan your channels back in again ok
he he he it was to late i had put them on again before i got your post ah well you cant win them all i suppose but thanks for getting back to me
hi guys looking for a bit of help friend of mine has starview1 its a clone when i scan in the channels no stations are showing it runs to the end but no channels are saved .any advice?
Make sure the incoming cable is in "Cable Input" at the back of the SV. Try this Menu > Factory Setting PIN 0000 OK to delete Turn box off at the back for a minute and turn back on English > Installation Choose Provider etc Automatic Scan Press OK Channels found Exit Press Menu then 1570 Turn EMU key ON Exit , exit , exit
Tried that it comes back saying no channels found,i went into manual scan and there is nothing on level or quality