1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

too much thermal grease?

Discussion in 'Xbox 360 - Modding & Hacking' started by therapy, Jul 7, 2007.

  1. therapy

    therapy Member

    Joined:
    Dec 29, 2003
    Messages:
    72
    Likes Received:
    0
    Trophy Points:
    16
    followed lawdogs guide to the letter on replacing the x-clamp mod, thing is i may i
    of used too much thermal grease, used 1.0g between both chips, was a nightmare to clean off it went everywhere, 360 booted before i did the mod for 10 mins or so but after got the 3 red lights (ring of death) after it got hot i presume because it would boot again after a cooling session , after doing the x-clamp mod i get the 3 red lights instantly no boot, hopefully somebody can correct me in my ways, im sure it can be fixed as it booted for a while before i did the x-clamp mod, have tried returning to using the original x-clamps but stil get 3 red lights instantly, wish i had just tried the towel trick now lol
     
  2. therapy

    therapy Member

    Joined:
    Dec 29, 2003
    Messages:
    72
    Likes Received:
    0
    Trophy Points:
    16
    goes to 2 red lights if left for a min or so overheating i believe
     

Share This Page