1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

TX Coolrunner question

Discussion in 'Xbox 360 - Modding & Hacking' started by CawkFour, Nov 13, 2011.

  1. CawkFour

    CawkFour Regular member

    Joined:
    Oct 20, 2008
    Messages:
    495
    Likes Received:
    0
    Trophy Points:
    26
    Last edited: Nov 13, 2011
  2. newtype07

    newtype07 Member

    Joined:
    Nov 9, 2011
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    11
    If you are asking this question, you obviously have no business trying to solder it to your board. Do plenty of research first, learn how to solder and use all recommended accessories such as the nand-x and CK3pro.
     
  3. CawkFour

    CawkFour Regular member

    Joined:
    Oct 20, 2008
    Messages:
    495
    Likes Received:
    0
    Trophy Points:
    26
    you sir, are correct. as i mentioned in this thread, i have no soldering skillz at all. i didn't want to keep derailing wabashman's DashLaunch v2.26 thread so i created this one.

    there is somebody in san diego that will do the rge hack for me but i have to provide the chip. he only provides the installation service. at first i found the matrix glitcher but jpizzle said that the tx coolrunner was much better over at elitemodscene.

    so again, is that the chip that i need or is there something else? thanks.

    also, once the rge hack is put into place, do you have to do additional solders to update the box or is the maintenance all software based?

    thanks.
     
  4. foxykay

    foxykay Member

    Joined:
    Jul 21, 2011
    Messages:
    52
    Likes Received:
    0
    Trophy Points:
    16
    I have heard good things about the TX Coolrunner.

    Your installer should have the equipment to dump your xbox nand and the equipment to program the cpld, I would recommend you check this. Other than this, this is all you need

    You don't need to resolder anything once its done, there is a xbox app that will allow you to update if you need to (Think its called flash360)

    PS. I cant see the chip on the link you provided.
     
  5. CawkFour

    CawkFour Regular member

    Joined:
    Oct 20, 2008
    Messages:
    495
    Likes Received:
    0
    Trophy Points:
    26
    thanks for the reply and the info. i must have copied the wrong url link.

    i ended up getting the executer coolrunner *link* from vgcrepairs. you saved me from getting the nand-x and some other equipment that i guess i don't need. thanks.
     

Share This Page