1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Where can I find V10 disassembly instructions?

Discussion in 'PS2 - Hardware boot discussion' started by Krystovar, Apr 25, 2005.

  1. Krystovar

    Krystovar Regular member

    Joined:
    May 12, 2004
    Messages:
    169
    Likes Received:
    0
    Trophy Points:
    26
    I've been looking around for instructions to help me disassemble my V10 PS2. I haven't been able to find anything with good instructions and good pictures. I got stuck at a point where I couldn't get a piece off. I think it's the power supply piece, and when I take out the 4 screws it still won't lift up because I feel some resistance on it near a little white piece with 4 thin metal rods inside it (looks similar to the 4-pin power connector of a PC power supply.)

    Anyone know of a site with clear instructions and or pictures? (For the record, I'll be installing a DMS4 EZI solderless, and I have the instructions for that, I just need to get it apart first.)

    Thanks!
     
    Last edited: Apr 26, 2005
  2. Krystovar

    Krystovar Regular member

    Joined:
    May 12, 2004
    Messages:
    169
    Likes Received:
    0
    Trophy Points:
    26
    This is a picture of the V10 power supply. I've circled the piece that seems to be giving me resistance. Do I just pull the power supply up, and the pins will stay in place (connected to the lower board)?

    [​IMG]
     
    Last edited: Apr 26, 2005
  3. Krystovar

    Krystovar Regular member

    Joined:
    May 12, 2004
    Messages:
    169
    Likes Received:
    0
    Trophy Points:
    26
    Figured it out, I just needed to pull up with a little more force around the part I circled, and the PSU slid right off.

    On a side note, I broke the connector to the case fan when reassembling everything, do you know if the PS2 will overheat if I run it without a fan?
     

Share This Page