1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Wiring a modchip

Discussion in 'PS2 - Hardware boot discussion' started by haloasis, Feb 8, 2007.

  1. haloasis

    haloasis Member

    Joined:
    Aug 5, 2006
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    11
    I'm buying a DMS4 SE Lite from someone and it's not pre-wired. Can someone point me in the direction I'll need to wire the chip? also, is it hard to wire chips yourself? Thanks in advance.
     
  2. ps2modgod

    ps2modgod Guest

    You will need the following

    -15 watt soldering iron
    -30AWG Kynar wire
    -24AWG stranded hook up wire for power and ground
    -Flux paste
    -Solder

    Soldering a modchip in a PS2 is not for the average solderer. If you are a novice you might consider having a pro look at it.

    Have fun!
     
    Last edited by a moderator: Feb 8, 2007
  3. vcbc

    vcbc Regular member

    Joined:
    Apr 15, 2006
    Messages:
    1,080
    Likes Received:
    0
    Trophy Points:
    46
    http://www.dms3.com/dms4se/index.html
    ps2modgod is right modding those are a pain. Flux is not needed, but makes the install alot eaiser. Also u might want to have a desoldering tool., in case u bridge something
     
  4. haloasis

    haloasis Member

    Joined:
    Aug 5, 2006
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    11
    my dad is pretty good at soldering things, i was planning on him doing it, lol, but yeah... i'll keep these advises in mind. thanks for the help guys :)
     

Share This Page