Hello, first time poster here. I decided to get a mod chip because I found out I could play custom Guitar Hero songs. I've never soldered anything before but everything is going swimmingly according to the multimeter (I'm using a Duo 3 Gold chip and have all of the BIOS wires and couple other ones done so far). So I decided to do the Romeo mod next and I thought I did it fine but I wasn't sure which pin it was on in the picture. So I did it on the 4th one up. Of course being dumb I decided to look to make sure it was that pin by searching on this forum AFTERWARD and saw that I went one pin too far. Am I screwed now? Or can I solder that pin back to the board and lift the other pin and just switch the wire?