1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Xbox liteon Laser Help

Discussion in 'Xbox 360 - Modding & Hacking' started by X3R0102, Nov 3, 2012.

  1. X3R0102

    X3R0102 Member

    Joined:
    Nov 29, 2008
    Messages:
    32
    Likes Received:
    0
    Trophy Points:
    16
    Someone let me know what I am doing wrong here. I have been having a hard time with a Liteon Laser replacment. My laser went bad so I picked up a new one when I installed it I did desolder it and then installed . When drive opens to play game lense moves down and up arm but I do not get any light from the laser. So I figured the laser was no good and got another. After desoldering that one and installing I got the same outcome. I then tryed to do a pot calibrate on it since it was reading in the high 4.0 and still no power to the laser. Can anyone give me a hand on this and let me know what I am missing
     
  2. peluynati

    peluynati Regular member

    Joined:
    Nov 18, 2009
    Messages:
    1,841
    Likes Received:
    0
    Trophy Points:
    46
    did you try replacing the ribbon cable that connects the laser to the board? are you sure its in correctly?
     
  3. Modking30

    Modking30 Regular member

    Joined:
    Feb 16, 2010
    Messages:
    3,169
    Likes Received:
    0
    Trophy Points:
    46
    If the laser is new, you should not have to do a POT calibrate. You need to make sure when you desolder that you see 3 solder points on the laser. Otherwise you haven't completely desodered it properly. Other wise as stated by peluynati, it's the ribbon.
     

Share This Page