So you can start the ps3 again after shutdown?
Its highly probable the lead free crap solder has cracked on the cpu or gpu.
c3401 capcitor 47u 10v ta http://www.megaupload.com/?d=U92WB2OX
Arctic 5 is the best and a seperate power supply is my next move. Mine has been running *****5 Months********* used daily, putting it down to...
crazy stuff
I see..I do have flux and stuff just waiting on getting a heatgun. today i used a hair dryer and AS5. cleaned out alot of dust from the console...
going to get a heat gun and try - does the above sound promising? Yes def sounds promising,use flux and new paste(super thin layer) I am on...
double check ALL ribbons are connected properly, are you getting the yellow then constant red flashing led? not all ylods appear to be recoverable
Dont know then, just guessing try putting old lense back in and see what happens maybe you bought a duff one, double check your ribbons they can...
Maybe??? I thought this, try pulling the battery cable and reconnect it, you sure you got the right lense or you got a cable wrong/bad connection,...
so if you had 1 worn tyre and the rest were good you'd change them all?
My first reflow lasted 7 days say 5 hours a day on mw2. Just reflowed again but this time only did the top chip (when stood upright), no point...
Well my solder reflow lasted 7 days :( Just reflowed one cpu this time (the top one when stood upright) and its alive again Have to admit...
My power supply area is cooler than a nuns crutch, so not sure about that theory. After lots of research I conclude that most YLOD is caused by...
hacking the ps3 with jailbreak has arrived, yeah baby, sony ripped me now I will rip them, every loser wins bleep
Separate names with a comma.
