bigazn, how the hell did you break that off!!! :) Were any of the physical electronics on that board damaged? With the simple functions of...
coldd, a lot of people have had problems with solderless mods coming loose. It was a big problem a year ago, but they've become much better. I...
Bomber_UK, I think your problem is the BIOS..... however, afaik, you're out of luck. :( Contact the Xecutor folks and see if I'm correct...
Tumashi, if you read your post, you say this: "The reason you get the red/green flash is because the main xecutor chip is coming loose because...
electwire, don't bother reading up 1/2 a screen please. You might see bomberman say this: I just chipped my v1.6 xbox with Execute 2.6...
Which BIOS did you guys use?
erfon, it fixed it for me twice in a row. I'm a good solder tech. I'll always use the pin header. It takes me about 20 minutes to suck the...
It's my opinion that it's difficult to get the xecutor chips working without the pin header install. Don't immediately suspect D0. It's the...
I wouldn't consider buying a new xbox unless I was sure it was the chip. If it still doesn't boot with the chip disabled and it still won't boot...
If you're looking at their 2.6 solderless, you don't want that. The regular 2.6 will work fine for you. It is cheaper and 1.6/1.6b compatible:...
well, this xbox was fine throughout the install after the fix I listed above. It fragged (red/green) once today. I tore it back down, sucked out...
I'm having the same issue (almost boots 3 times and then flashes red/green) with a recent 2.6 on a xbox1.1 with the wire-solder method (LPC was...
Separate names with a comma.
