Kafluke burn the file onto a data dvd with nero and it should work ok you might have burnt the disk as an iso
yes you can mod the gamecube with a viper chip and you will need a 4.5 mm game bit or melt the end of a bic pen and use that there is plenty...
take your board back out turn it over and follow the lpc rebuild on this link http://pictures.xbox-scene.com/4/duox/duox2_v1.6.jpg you should be...
i gather by ignoring my question have you rebuilt the lpc port you dont know what it is if you want help then answer m8 its a simple question...
Threet76 i would say you have bent or broken a pin in the hard drive where the ide cable plugs in
have you rebuilt the lpc port
dosent the beep meen it can not find a bios to boot from somebody please corect me if i am wrong if that is the case you might have broken the do...
have a look at the back of the hard drive where the ide cable plugs in you might have to take out the hdd fron it cradle to have a good look
make sure you havent bent or pushed in any of the pins on the hard drive conetor you might just be getting a hard drive timeout
"I got a message on my t.v. that said my xbox needs work." did it come up with an error code at all this would help
the xecutor 2 light plus looks a good option i havent fitted one of these the only problem i can see with it is if you tighten the screw up too...
the executer 2 is by far the best i have used to date not had one problem with them at all i know its a solder one but to be honest it is so...
where abouts are you i would gladly have a look at it for you if you are not too far away posting it would be a bummer cause it that heavy
what is the error code that come up will help a lot if i knew it m8
you need to use flash fxp then connect your xbox directly to pc via a cross over cable then you need to set up your network card to connect to...
Separate names with a comma.
