I tried nero to create the disk and no matter what setting I changed it wouldn't create a readable disk. I ended up using recordnow and it worked...
Sorry I cant be of any help, I would contact console-corner though. The only info I found on the web where it mentioned frag was a bad bios.
Actually I had a problem with the scex connection where the resistor had lifted enough to break the connection. It gives a black screen, does not...
Go here http://www.xbox-scene.com/tutorials.php?t=0,0,0,1,0,0,0,0,0,0,0,0 under xbox iso tutorials and download the craxtion guide.
I think its because your not spelling it correctly. http://www.craxtion.com/
Its possible you could have a bad download of the bios, I was helping someone else on here that ended up being their problem, but more than 1 bios...
Heres one more piece of the puzzle that you might not be doing. You have to have the switch board plugged into the chip and switched to enable to...
I suspect your bios is fine just being used incorrectly along the way. When you created your bios file, did you name it bios.bin (all in lower...
I think its because your cable is too long. The way I got it too work is plugging the programmer directly into the parallel port in the back of...
Assuming the cable wasn't damaged...on the connector on the motherboard use your fingernail to lift up on the top of the connector (if I remember...
Recordnow max tutorial http://www.cdrforum.cc/article.php?13.0
Why is it hard to burn? Just select the filename thats not followed by numbers when you go to burn, its like an index file and knows to go get...
Yes you still need to download a bios, no you don't have to solder if you have lite+ or lite/pro adapter and as far as determining version go here...
Sounds similar to a problem that I was having connecting to the internet (I have a linksys router with cable broadband). I had to rerun the...
Yes the scex and from my own experience no it doesn't work without it. You get the results you described, but if you checked it then thats not it.
Check the resistor where you soldered your "s" connection and make sure it didn't lift off the board.
Yes I did get it from the same place and no I didn't get it through IRC. I got a link to a site from someone that I emailed, its since been...
Thats exactly what I was talking about. No matter how much you try to position it will always shift off when you tighten down, a little or a lot....
Then try kfree's suggestions, double check your d0 point after screwing it down to make sure it isn't shifting off.
If you got your chip from the-console-corner like I did and others on here, they apparently have a bad batch where the pins dont align, it has...
Separate names with a comma.
