Awesome tutorial! Im guessing iso2god doesnt run on externals?
anyone have a correct way of setting up an external drive to run iso2god rips??
I've downloaded this but i'm have some issues. It says to upload the .data folder, which I do. When I do this it starts to convert back to an iso,...
Well the idea was to remove and create more room for cooling methods for my 360. But i received my answer, thanks!
OK this more like a mod but I'm posting where ever I can find help, but I'm trying to eliminate my DVD drive from my 360. If anyone could...
That is one clean install! Kudos my man! I was gonna do the coupler as well but then decided not to since I don't use my cable anymore.
I have a question. I downloaded bioshock 2 as an iso from a torrent site how do I run this games from my hdd? I've noticed when i extract the iso...
I you followed the tutorial correctly then you should have made a folder named nandpro on the root of your harddrive on your PC. That's where your...
either one should work fine as long as the drivers for nandpro are installed properly. if you get an error when you try to flash you might have to...
Any lpt cable is fine as long as it has a male end. Chop off the opposite end seperate the wires add the resistors to the required wires. Then...
if you're brave enough you can try that link which shows you how to flash via usb using nandpro.
It could work you're gonna have to re-do the pins to the points on he board. Not to mention adding the resistors. You better off getting a network...
You're better off using the 1n914 diodes which work way better for this hack. you can order them here or here at radio shack . I used these and...
follow this exactly! 1) Extract KV and Config blocks from nand.bin nandpro nand.bin: -r16 rawkv.bin 1 1 nandpro nand.bin: -r16...
yes, if it comes out fine then its working. just makes sure you inject the kv and config to xbr afterward and flash again. sounds like a pain i...
yes you need these files injected into xbr in order for your 360 to boot. you need to compare the read of the xbr dump to the xbr you flashed to...
well you can always flash back to you original nand dump to once you're done with it, but it wont boot unless you take off the jtag wires.
did you flash xell itself or did you flash xbr? If you did just the xell image then i would suggest you go back and erase the nand and then flash...
Unplug the console then plug it back, before you start the console with the power button press and hold the eject button which will load xell.
Very good point!
Separate names with a comma.
