amcap driver.....no video capture hardware error message ??

Discussion in 'Video capturing from analog sources' started by ANTIQCOOL, Mar 11, 2008.

  1. ANTIQCOOL

    ANTIQCOOL Guest

    Hi,

    Just bought a webcam (pc14-8 led 1.3 megapixel web cam. All I want to do is record some video for youtube but I know little about video capture hardware/software.

    According to the manual I have the correct system requirements and installed as per instructions using the AMCAP driver supplied on disk with the web cam But the following error message appears...

    Sorry, you have no video capture hardware......can anyone diagnose the problem ??
     
    ANTIQCOOL, Mar 11, 2008
    #1
  2. retsam360

    retsam360 Member

    Joined:
    Mar 17, 2008
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    Hi there, actually we have the same problem, did you find any solution to it? If you do, please tell me pls, tnx.:=)
     
    retsam360, Mar 17, 2008
    #2
  3. powercom

    powercom Member

    Joined:
    Apr 26, 2008
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    Because you haven't finished installing the software.

    Your next step is to plug in your camera into the USB port.

    Make sure the icon appears from the deskbar.

    If it doesn't appear, it will display no video capture hardware.

    So, dun make yourself pain in the a## by trying to open the AMCAP, just then.

    Replug a few times, it will then proceed your installation by copying files to your folder.

    Re-start. And it's ready to use.

    Hope this helps.

    G.
     
    powercom, Apr 26, 2008
    #3

Share This Page