Audio Issue

Discussion in 'Video playback problems' started by dataport, Sep 2, 2008.

  1. dataport

    dataport Member

    Joined:
    Mar 11, 2007
    Messages:
    36
    Likes Received:
    0
    Trophy Points:
    16
    Need a simple way to increase audio in an AVI file - to burn and play on my Philips Divx player (some are way to low to hear).

    Used Virtual Dub:
    - Loaded AVI in
    - Video - set to "Direct Stream"
    - Audio - set to "Full Processing"
    - Audio-Volume - increased volume

    This increases size from 700M to 1.5G - which is OK, but creates either a sync problem to voice - or sometimes no audio at all.

    Anyone have any suggestions? Tried using nandub - same results.
     
    dataport, Sep 2, 2008
    #1
  2. attar

    attar Senior member

    Joined:
    Jun 17, 2005
    Messages:
    11,147
    Likes Received:
    41
    Trophy Points:
    128
    Are you selecting an audio compressor - else it's uncompressed output.
     
    attar, Sep 2, 2008
    #2
  3. dataport

    dataport Member

    Joined:
    Mar 11, 2007
    Messages:
    36
    Likes Received:
    0
    Trophy Points:
    16
    Didn't select an audio compressor - comes out PCM which doubles the file size. This then gives me a slight sync problem most of the time.
     
    dataport, Sep 2, 2008
    #3
  4. davexnet

    davexnet Active member

    Joined:
    Jul 7, 2003
    Messages:
    1,856
    Likes Received:
    0
    Trophy Points:
    66
    If it gives a sync problem, use audio/interleave skew correction
    to either advance or retard the audio.
     
    davexnet, Sep 3, 2008
    #4

Share This Page