1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.


Discussion in 'PS2' started by jose3526, Feb 28, 2004.

  1. jose3526

    jose3526 Member

    Aug 7, 2003
    Likes Received:
    Trophy Points:
    I recently installed a no solder modchip on my v7 PS2. After installation my disc drive would not open. I have been searching for info, and I now believe that I have blown a fuse. Does anyone know what type of fuse I should replace and where it is located. Thanks in Advance!
  2. Gndcomm

    Gndcomm Guest

    I tried the no solder mod chip and it blew PS1. I replaced PS1 and ever so carefully installed the no solder mod chip again, same thing. Replaced PS1 and went with DMS mod chip. Very happy with it although the installation was somewhat complex. When PS1 blows you have no power to the PS2. It is if it is unplugged from the wall outlet. I got a replacement from Digikek. I used a microscope to aid in installing the PS1 fuse.

Share This Page