booting GCOS 1.5 on Viper and using AR codes

Discussion in 'Nintendo Gamecube - General discussion' started by Kafluke, Jul 30, 2006.

Thread Status:
Not open for further replies.
  1. Kafluke

    Kafluke Active member

    Joined:
    Jul 17, 2004
    Messages:
    1,368
    Likes Received:
    0
    Trophy Points:
    66
    I have decided to flash my Viper with GCOS 1.5 and I couldn't be happier. The better compatability and forced NTSC is a dream. The only down side is that I can't figure out how to load my AR codes now. The cobra 1.6 bios supported this natively and it was a simple process to enable them. Does anybody know how I would go about enabling AR codes with the GCOS 1.5 bios booting off my ViperGC?
     
    Kafluke, Jul 30, 2006
    #1
Thread Status:
Not open for further replies.

Share This Page