Burn Speed slowed down ???

Discussion in 'Copy DVD to DVDR' started by ScubaZ, Feb 9, 2008.

  1. ScubaZ

    ScubaZ Member

    Joined:
    Feb 9, 2008
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    Hi there,
    i use anydvd and clonedvd2 to back-up my dvds, and burn on a lightscribe DVD+-writer, the burn process used to take between 15 minutes and half an hour, then suddenly one day it started to take 1 - 3 Hours. What happened??? help please
     
    ScubaZ, Feb 9, 2008
    #1
  2. iluvendo

    iluvendo Active member

    Joined:
    Oct 19, 2005
    Messages:
    3,118
    Likes Received:
    0
    Trophy Points:
    66
    Last edited: Feb 9, 2008
    iluvendo, Feb 9, 2008
    #2
  3. binkie7

    binkie7 Moderator Staff Member

    Joined:
    Feb 12, 2005
    Messages:
    17,588
    Likes Received:
    0
    Trophy Points:
    116
    Here's a guide to check and get it back in DMA mode - link
     
    binkie7, Feb 9, 2008
    #3
  4. iluvendo

    iluvendo Active member

    Joined:
    Oct 19, 2005
    Messages:
    3,118
    Likes Received:
    0
    Trophy Points:
    66
    Hiya Bink, warmer where u r I hope as 70 degrees?
     
    iluvendo, Feb 9, 2008
    #4
  5. binkie7

    binkie7 Moderator Staff Member

    Joined:
    Feb 12, 2005
    Messages:
    17,588
    Likes Received:
    0
    Trophy Points:
    116
    Not yet but I have hope :)

    @ScubaZ
    Make sure your firmware is up to date on the burner too.

     
    binkie7, Feb 9, 2008
    #5
  6. ScubaZ

    ScubaZ Member

    Joined:
    Feb 9, 2008
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    You guys are good.
    had the problem fixed in no time,
    thanks
     
    ScubaZ, Feb 9, 2008
    #6
  7. ZoSoIV

    ZoSoIV Active member

    Joined:
    Oct 24, 2007
    Messages:
    3,454
    Likes Received:
    0
    Trophy Points:
    66
    ZoSoIV, Feb 10, 2008
    #7

Share This Page