Can't boot into safe mode OR normal mode

Discussion in 'Windows - General discussion' started by Darkhadou, Jun 8, 2008.

Thread Status:
Not open for further replies.
  1. Darkhadou

    Darkhadou Regular member

    Joined:
    Dec 31, 2004
    Messages:
    648
    Likes Received:
    0
    Trophy Points:
    26
    Right, so I jut booted up my PC after installing my graphic card drivers and it would crash. I then did a repair install via the CD but towards the end of the installation where it boots into normal mode, instead my PC loads safe mode.

    The PC then presents an error saying "Windows XP Setup cannot run under Safemode. Setup will restart now". It restarts but it goes back into safe mode and have no idea how to turn safemode off (since I forced it through msconfig back when I could actually access normal mode).

    Are there any boot commands that would allow me to edit the boot.ini and turn off safeboot ?
     
    Darkhadou, Jun 8, 2008
    #1
Thread Status:
Not open for further replies.

Share This Page