Hello peeps! Need help bad!!! I am new with this so please bear with me...1 Dish and 2 receivers (both COOLSAT 5000). After the install everything was working perfectly. But after a few weeks I was experiencing no or bad signal on one of my receivers. I thought it was my dish but i guess not. here goes. 1 receiver in the living room and 1 receiver in the bedroom. The bedroom receiver works fine, but the living room receiver works for a couple of hours and then goes to no or bad signal. I switched the receivers and still works for a couple of hours and goes to no or bad signal...now it is permanently on no or bad signal. What can I do to fix this? Do you think I have a defective receiver? PLEASE HELP!!!
Go to the main thread here and they will help you solve the problem http://forums.afterdawn.com/thread_view.cfm/134/353430
Celtic71, Do you know which page on the main thread? I have been reading since last night and I couldn't find the right answer. =)
If you post your problem over there , they will respond to you quicker , sorry I dont know the answer for coolsat
I really couldn't find anyone to help me on that thread...everyone is too busy updating to 147...this sucks!
Have you tried resetting your receiver and loading 147? You might want to also check to make sure your sat settings are set up properly.
Yes. I have tried resetting and loading bin 147. Still no or bad signal. The problem I have is the other receiver is working perfectly and this one is not...this is getting really frustrating! =)
