CycloDS Evolution Problem

Discussion in 'Nintendo DS' started by Whitefang, Dec 5, 2009.

  1. Whitefang

    Whitefang Member

    Joined:
    Mar 15, 2005
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    I got my Cyclo DS Evolution this morning and updated it to the newest firmware. I played a game to make sure it was working then turned it off. I downloaded a few more games onto my 8GB card and went to play a new game and now it will not even recognize I have the Cyclo DS plugged in. I tried a normal DS game and it worked fine. Any ideas?
     
    Whitefang, Dec 5, 2009
    #1
  2. lumpybuns

    lumpybuns Member

    Joined:
    Sep 9, 2009
    Messages:
    18
    Likes Received:
    0
    Trophy Points:
    11
    Did you start by removing the games you added that messed it up?
     
    lumpybuns, Dec 5, 2009
    #2
  3. Whitefang

    Whitefang Member

    Joined:
    Mar 15, 2005
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    Yes I took all the games off and formatted the media. I tried turning the DS on with no games loaded on the media at all and even tried putting the new firmware onto card to update again. Still doesn't recognize the Cyclo is installed.
     
    Whitefang, Dec 5, 2009
    #3
  4. Squigs

    Squigs Member

    Joined:
    Nov 24, 2009
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    I know from past experience with a couple of my cards that sometimes you have to take the card out and re-insert it a couple of times before it loads up.

    As daft as it sounds, the most reliable way of getting mine to boot every time is to breath (not blow) on the card terminals just before you put it into the DS.

    Squigs
     
    Squigs, Dec 6, 2009
    #4

Share This Page