DBox2 blank LCD after 'Lade.....' no image boots

Hi,

DBox2 turns on and LCD shows first screen, then second screen with combination of numbers/letter(Shown in new start guide to identify debug mode)states 'Lade...' at bottom of this screen then blank....nothing at all!

Dbox2 worked fine and I was trying to fix the april problem everybody had and everything was going well until I was trying to change the image on the DBox2 after flashing new image. The debox2 froze and after several hours could only cut power and the above mentioned problem hapens everytime! Can't connect to DBox from PC at all now to do anything.

Any ideas?

Thanks in advance!

 

Use IFA and flash a fresh image.

 

And make sure its the right image - if your dbox2 has 2 chips then the image should be x2 - I suspect your in this situation in the first place by flashing the wrong image.

 

That Process would result in Kein system .......Paul