DMA issues

Discussion in 'Nero discussion' started by jade32, Jan 1, 2007.

  1. jade32

    jade32 Guest

    I changed my primary and secondary IDE channel properties from pio to DMA on device 0, and on current transfer mode it says Ultra DMA mode.
    However, on device 1 it was already set on DMA, but on the transfer mode of device 1, it says "not applicable". Is that a problem? That was on both primary and secondary.

    Jade32
     
    jade32, Jan 1, 2007
    #1
  2. Saltgrass

    Saltgrass Regular member

    Joined:
    Apr 2, 2006
    Messages:
    1,116
    Likes Received:
    0
    Trophy Points:
    46
    If you don't have any devices connected, it will say that.
     
    Saltgrass, Jan 1, 2007
    #2

Share This Page