DMS3 V2.0 on V9 PS2

Discussion in 'PS2 - Hardware boot discussion' started by Kafluke, May 1, 2005.

Thread Status:
Not open for further replies.
  1. Kafluke

    Kafluke Active member

    Joined:
    Jul 17, 2004
    Messages:
    1,368
    Likes Received:
    0
    Trophy Points:
    66
    I have checked all my solder points multiple times. My PS2 acts as if no chip is installed at all. I have a few questions as tutorials and or pics and guides were very next to impossible to find for my config.

    1. I see not solder point on the DMS3 v2.0 for CLK??? Is it needed to work?

    2. Do I have to load some bios or firmware before anything will happen?

    3. What do I hold on boot up to go into the config and turn the thing on?

    4. Even if perhaps I didn't have o-w soldered correctly for the Optical drive, shouldn't I still be able to get into the config screen?

    Somebody please help me on this as I am completely lost! Thank you!

    Kafluke
     
    Kafluke, May 1, 2005
    #1
Thread Status:
Not open for further replies.

Share This Page