dreambox500c -how to flash

Howdy, can anybody give me the ABC guide to flashing my dreambox 500c with a nullcable? I have connected the laptop to the box thru the wireless router but the flash button does not activate

 

New tutorial

1. You will need relevant software so that your box can be fixed properly.

Dream up, Flash Wizard. Dreambox Control Center. Extract the file and autorun the program. A small box will appear with the relevant software.

http://rapidshare.com/files/109770655/DreamboxForEver.rar.html



2. Now you need this image i have FULLY WORKING! This is a flash wizard file and need to be flashed through the flash wizard program or through Dreamup . PLACE THIS IMAGE ON YOUR DESKTOP. EASY TO FIND.

Flash Wizard Image:

http://rapidshare.com/files/110539401/dwemptyautoroll.fw2.html

Null Modem Image:

http://rapidshare.com/files/110539456/dwemptyautoroll.img.html

3. Now that you have downloaded the WORKING IMAGE. Connect to your dreambox via DCC. You will need your Dreamboxes ip address for this. If you do not have it and have an image already on you box. Go into the setup, expert, communications. Your ip address will be in here.


4. Once you have connected to the dreambox. Open Flashwizard. Go into configuration and ultilies at the bottom of the box. Make sure the ip of the dreambox is the same as the one in dcc. It should be. If not change it.

Now Click Install a Firmware to flash memory. Now you will need my WORKING IMAGE. You downloaded above. Click the open folder tab. Browse for the image. Should be on your desktop as instructed above. Click open.

The image should now be visible in the box.

Now click flash image backup. This will install the image to your box.
Takes approx a minute.

Once completed reset the box. PLug into ur tv. And try.

It should now show that the flash is installed.

Do the scan using your area. For example Uk or ntl ie etc.

Once the scan has finished check your channels. TRY SS1 FIRST. If you dont have the channel. Reboot box. This time the evocam should startup and will roll the channels.

This is the simplest way to install this image. If this doesnt work or you have problems connecting to your dreambox you will have to go down the null modem route. Please leave me a message if you have problems with this.

Null Modem Fix:


You will need a program called dreamup.

http://www.dream-multimedia-tv.de/download/DreamUP.zip

Then download the image. The null modem one. Save this to desktop.

You need to plug the null from the box to pc.

With the dreambox switched off start up dreamup program.

Then untick use network box. Then click connect. Startup the dreambox.

It will connect. The flash box will then open. Click this it will ask for image. The image you downloaded open that. Then it will flash the image to your box. If asked to flash erase click NO!

Then flow the rest of the procedure mentioned in previous posts.

Thankyou

Chris

 

Thanks Chris,Very grateful for your help.
I will try tonight. I would buy you a pint if you were here now.

Best Regards

Jim,

 

spam removed

 

Too right you can never have enough instruction. Thanks for your response

 

I ordered a null cable for connection to the dreambox and my laptop to match the pins but I am still unable to flash the file. Any ideas as I think it says there is an 'FTP' issue? Whats different about a null cable anyway? frustrated!