1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Drive tray won't open on BenQ plus red light (E65)

Discussion in 'Xbox 360 - Modding & Hacking' started by Pheenoh, Apr 11, 2009.

  1. Pheenoh

    Pheenoh Member

    Joined:
    Mar 30, 2009
    Messages:
    22
    Likes Received:
    0
    Trophy Points:
    11
    I was trying to get my drive into vendor mode using JF (I was using the Device ID/Unlock Vcc Trick) when my computer froze. I turned off my 360 and unplugged the plugged my computer. I turned it back on to try it again and the green light kepy continually flashing and the drive tray wouldn't open. I hooked the drive back into the 360's motherboard and got 1 red ring. Help?
     
  2. PS2Menace

    PS2Menace Regular member

    Joined:
    May 1, 2006
    Messages:
    2,825
    Likes Received:
    0
    Trophy Points:
    46
    Use dosflash to flash it. You got 1 light because the drive has NO firmware on it. You must have erased it somehow. Better hope you got your key (orig.bin) file first.
     
  3. Pheenoh

    Pheenoh Member

    Joined:
    Mar 30, 2009
    Messages:
    22
    Likes Received:
    0
    Trophy Points:
    11
    I never even got it into vendor mode, so is it impossible to get orig.bin now?
     
  4. rage4ordr

    rage4ordr Regular member

    Joined:
    Feb 16, 2009
    Messages:
    140
    Likes Received:
    0
    Trophy Points:
    26
    If you don't mind, I'm gonna subscribe to your thread. I can't seem to get my drive into vendor mode either and I'm getting the flashing green power light too after I try to get my drive into "half open" mode.
     
    Last edited: Apr 11, 2009

Share This Page