Having trouble installing the DUO3 in my 77001 (GH-051-12) ps2. The website for DUO3 only shows the DUO3 GOld diagrams with the right motherboard number as mine. BUT for the last wire i have a Y and the diagram shows an X. i wonder if it solders in the same place? the diagrams i have found for the DUo3 dont show the same motherboard number as mine and its a differnt layout. any ideas?
I guess you over looked these http://www.duomodchip.com/english/install/duo3/duo3_gh51_02.jpg http://www.duomodchip.com/english/install/duo3/duo3_gh051_51.jpg Have fun!
well it boots original games but goes to the red screen saying insert a psx or ps2 game when i try to boot a dvd-r game.
Damn that sucks! If you have a digital volt meter with a continuity tester I would recommend going over your install verifying all your points are correct. Can you post a picture of your install?
i got it, but is very picky on the games. DVD-r games that would boot up with no problems with my Ver7(39001 w/ magic2) are taking forever to load or going to the red screen to insert a psx/ps2 game. after playing a game for a while, the DUO3 led light would go out by itself. the chip seems unstable. how do i put the chip in siabled mode cause holding the RESET for 5 secs puts the PS2in standby mode.
The Duo3 is knows to be temperamental and have a poor boot rate on the new V15's. I was going to suggest the resistor fox but I see you have already found your answers at ps2-scene.org
chip sucks everyone. some games load, some dont, some freeze up in the middle, its terrrible. new chip time
