Enable/Disable Switch

Discussion in 'Xbox - General discussion' started by Drew224, May 2, 2003.

  1. Drew224

    Drew224 Regular member

    Joined:
    Apr 9, 2003
    Messages:
    110
    Likes Received:
    0
    Trophy Points:
    26
    Is there a different jumper to hook an enable/disable switch to if I am using the pogo pin adapter with an X2 lite?

    Also, does the v1, v1.1 bios selection jumper even matter after I've flashed the chip with a 1MB bios (4 x Xecuter 4976.02)?



     
    Drew224, May 2, 2003
    #1
  2. JAYO

    JAYO Member

    Joined:
    Feb 13, 2003
    Messages:
    43
    Likes Received:
    0
    Trophy Points:
    16
    no, you just hook the diable switch on the chip itself...there is no difference.

    V1 and V1.1 bios jumpers are for xbox bios not chip bios.....if you have a version 1.0 xbox, hook it up to V1.

    And if you have a V1.1 xbox.....hook up the V1.1 jumper.
     
    JAYO, May 2, 2003
    #2
  3. Drew224

    Drew224 Regular member

    Joined:
    Apr 9, 2003
    Messages:
    110
    Likes Received:
    0
    Trophy Points:
    26
    On my chip the jumper makes no difference. I tried to connect a switch and it didn't work so I tested the jumper manually and it didn't matter if it was on or off. That's why I was asking.
    Is there any reason you can think of for this.
     
    Drew224, May 2, 2003
    #3

Share This Page