hi guys, have a eurovox tx and am looking to loop the signal round the house using an existing loop i have installed which has previously worked perfectly with other providers. the way it worked on other boxs was to plug a male lead into the tv/video(loop) out connection on the box which sent that signal to an amplifier(in the attic) and lastly split the signal to other connections. it wont do the same on the eurovox tx for some reason. i have even tried bringing another tv right beside the main tv where eurovox tx is and connected second tv to eurovox using 3ft lead via tv/video(loop) out connection but still cannot get scrambled channels i.e. movie channels on second tv. does anyone know does the tv/video(loop) connection on the back of the eurovox tx send scrambled channels such as movies or is it limited to the unscrambled stuff like rte1 etc. thanks in advance.
I would think that it would only be allowing the co-ax signal to pass through the box, rather than doing anything to unscramble the signal
thanks for the opinion sg8, i would think from the results i am getting you are right. do you know is there anywhere i can get a look at an online manual or instructions to see if i can get a definetive answer?
phil43 hi and thanks for the opinion. i am not sure that your right though unless i am doing something seriously wrong. i plugged a standard coax cable into the tv out on the back of the eurovox directly into a 2nd tv sitting directly beside the original tv and eurovox and did an auto scan but could not get the 2nd tv to display the same picture as the 1st tv. maybe i screwed it up. any further advice you have will be well recieved and again, thanks for the opinion. 04819d
You could be right.It is a while since I used the TX box.I seem to remember now that there is only 1 coax output on that box while the Digivox T has 2.Having said that did you try a manual scan on your second tv using UHF frequency.Worth a try.
