Eurovox TX series flash software

Hi
I recently received a Eurovox TX series receiver (for ch***s mmds in Munster)
I cannot find any software to flash it.
Can anybody help on this matter?
Thanks a million
Nahag

 

In Eamos at the end of my post. Look in the Eurovox folder, then the TX folder. You will find both the loader and the 23/11/07 firmware.

 

Thanks a million especially for the quick reply...that was my first post! I'll look at it now.
Nahag

 

Ok I apologise for lack of knowledge but I am having trouble flashing the box. I downloaded the .bin and .exe files. Then I ran the .exe file and selected the firmware tab and browsed for the .bin file and inserted it. Then clicked "execution". After a few seconds it comes up "flash failed". The display on the box did not change.
Can you once again bail me out? I have never done anything like this before so your help is greatly appreciated.

 

What cable/cables are you using?

 

Not quite sure of the name of it but it's a 9-pin female-female cable. Is this enough detail?

 

Yep are you sure its a null modem cable? Where did you get it from?

 

I got it from a friend. But since you just cast such doubt over my cable I decided to get my own and "Download Complete" just appeared!
Thanks very much. I really appreciate your help.
Regards,
Nahag

 

You're welcome enjoy

 

scOuser, how is things . i got a person looking for a box . something like the sky plus box .(mmds)could you suggest a box that would work like it.

 

Is it for N** MMDS or Ch***s MMDS?

 

c#or#s scOuser.

 

Ease of use Eurovox TX, The Box T, Digivox T. You could also look at a Dreambox T but not exactly plug and play.

 

Hi again!
Thanks agian for your help last week.
I tried to install the Eurovox TX box I was asking about last week but it doesn't seem to have "unscrambled" all the channels, I can only see the basic channels. Is there a code or some kind of update I need to apply once I have installed it?
Any help would be appreciated,
Thanks,
Nahag

 

What does it say in system info?

 

I don't know off hand. You see I'm installing it in my in-laws house (hence the pressure to get it done!!) and they have no internet there.
So I have to go back out there and try it every time...pain in the @ss really! Do you have any ideas what might be wrong? I know its a lot to ask of you when I cant even answer your question but it will be a day or 2 before I can get back out there and find that out.
What can I tell you other than I set it up, then used the auto-scan, it found 118 channels but only unlocked the standard available channels.
I don't know if anyone else had this problem or not...anyway any help would be great,
Thanks again,
Nahag

 

Just leave it on sky sports and let it sit, it will decode eventually.

 

No problem quite understandable. When you get back there make sure it says 231107 in system info. Also make sure ant power is on. If its still not updating just power it off and back on again.

EDIT: Hi SG

 

Thanks a lot.
I'll make a point of going out there tonight and checking this out,
Nahag

 

Hi again!
I checked the system info and it had something like TX_23_11_07 which I presume is right? Antenna power was on. I really don't know much about these boxes and this is my first time installing one so I'm pretty lost!
Anymore help!?
Thanks,
Nahag