Euroxvox scart to VCR connection

Discussion in 'Digital TV - UK & Europe' started by gregmis, May 22, 2008.

  1. gregmis

    gregmis Member

    Joined:
    May 1, 2008
    Messages:
    33
    Likes Received:
    0
    Trophy Points:
    16
    I just installed a Eurovox TX MMDS and everything works fine except when I connect my VCR/DVD combo to the VCR port. I lose picture, then get a message "Bad/Scrambled Channel" and a very loud humming/buzzing noise from the TV. I'm using a fully pinned Scart cable.. any ideas ?
     
    gregmis, May 22, 2008
    #1
  2. sc0user

    sc0user Senior member

    Joined:
    May 31, 2007
    Messages:
    13,111
    Likes Received:
    0
    Trophy Points:
    116
    Have you tried another scart? For tuning purposes the Eurovox is normally preset to C40 ,which is 626MHz but can be changed to whatever you like within the tv config menu.Its best to change it to something that wont clash with your terrestrial channels. As this may be the case as you are using the ANT socket on the TX for obvious reasons.

    A fully pinned scart may also cause some back feed.
     
    sc0user, May 22, 2008
    #2
  3. gregmis

    gregmis Member

    Joined:
    May 1, 2008
    Messages:
    33
    Likes Received:
    0
    Trophy Points:
    16
    Thanks I will try another (less pinned scart). Also I dont have any terrestrial channels tuned in, I am running solely from Scart on the Eurovox to Scart (AV1) on the TV
     
    gregmis, May 22, 2008
    #3

Share This Page