I have checked the help files for finding mssing channels but don't understand exactly how to do it:- "I have seen a few posts about channels missing when doing a full scan. Here's a little trick you can try that may help if you're having problems finding any particular channels or are missing channels: Try and determine the lowest transponder frequency that you can get a signal on. Look at the frequencies you already have on the channels saved so far and choose the lowest. Then in the installation menu select MANUAL SCAN and set that as the frequency. Make sure you can see a signal and scroll down to Network scan and change to ENABLE with the Right arrow. While still highlighted, click OK. Scanning should then begin. It will say 1/1 to start with but should then jump up to 1/?? (the ?? being 2 digits). Using this method my Starview indicated it scanned 56/56 transponder frequencies as opposed to 48 in Auto scan on one main provider. I also gained a few extra channels. The other transponders may have been picked up by scanning other providers." In particular i do not understand:- "Try and determine the lowest transponder frequency that you can get a signal on. Look at the frequencies you already have on the channels saved so far and choose the lowest. " I have a strview genuine box.
1. Currently I'm in Scotland using my brothers box but I will shortly be going back to Lewisham area. 2. i don't know how to fix.
have a look when your flicking through stations you have u will see in the box that comes up when you change station something like 110.000 khz 200.000 khz ect. the lowest one you see do this go into installation then into manual scan and put in the down freq the lowest one you found put in your symbol rate 6.952 or 6.887 then down to network scan flick across to enable press ok
