trying to flash blade 2 sagem dbox,am getting file transfer failure message after 10% crossover.i get message from box asking do i wish to overwrite?i click on it and then the crossover stops.do i need to try another image or am imissing something out?
Is it a 1X or 2X box? Use flashcheck to find out and then using either a 1x or 2x image, use IFA to flash. You will find both in Eamos at the end of my post.
hello again,i have successfully flashed blade trinity.i am now stuck on the scanning process!do i have to chaange the net-id,frequency and the symbol rate to progress....if so have you any ideas as to what to.
sorry schoolboy error,have read forum after googling scanning blade and found solution to auto change blade net-id for my area.d-box is scanning as i type.
am avin no joy with scanning,runs transponder scan,sets up bouquets,but no pictures,box is flashing=no e.p.g!.any suggestions
Where are you and who is your provider? I presume its Blade Quad you have used? Apologies but hitting the road soon.
Thats an older image without the correct ROM files, (you could FTP over the ROM files). But much easier to flash with Blade Quad as it will have all you need. You will find it in Eamos at the end of my post. Apologies but I am off to bed. Just flash with Blade Quad and set your location, scan ,(or ftp your services), that will sort you out
blade quad will not flash=says file is not correct size.have reflashed with latest anromedia because size was exceptable,,,after scanning all i get are the channels found on freeview
could not identify the material u mentioned.have flashed new pacino image and all is workin well.........thanx very much 4 your help,have finally got there,,,was an education.
