Hello, newbie here. I've searched the forums section and found this topic but could not respond because it was too old. The forum did not completely answer my question either. So here it goes... I've been using my AVR 335 for a couple of weeks now. Yesterday, I turned it on and it went into protect mode. I've tried all of the troubleshooting techniques listed in other threads with no success. I've have everything disconnected (except power) and it still goes into protect mode. Any suggestions? Am I going to have to take it to the doctor? Thanks
@jsauer 1) try unplugging for about 15 minutes and then replug and turn on 2) if suggestion 1 fails, go see the doctor
