Hi guys.... have got SV box (genuine) with 0 on front lcd screen..so gonna foillow this set of threads...but a question....when it says to remove c21....i assume you remove it carefully so as to re-use it...?? And when c21 is removed..i asuume the original c11 cap is still in place while i boot up...and then turn off again,until i see that it has booted up ...?? Then once it has booted up..and been turned off..is this the point at which i replace c11 with the new cap at c11..of similar values....(1000mic @16v)...?? And also now replace the origanal c21 back in place too....?? Would just like to make sure i have read this thread properly before doing this procedure... Thanks for reading this.... Billyie
hi..sorry the messsage above was suppossed to be a reply to a set of messages in another thread .. but i pressed "new thread" instaed of "reply". With my present problem, I lose control of the SV box..but it has left me with a zero on the lcd screen of box. Seemingly this is due to a capacitor problem....And i just needed clarification..if any one here can confirm that i would be doing the correct procedure before starting..... Thanks for ya help....... Billyie.
