HELP PLease!

Discussion in 'Nintendo Gamecube - General discussion' started by Sumone157, Nov 15, 2005.

  1. Sumone157

    Sumone157 Regular member

    Joined:
    Feb 5, 2005
    Messages:
    333
    Likes Received:
    0
    Trophy Points:
    26
    Help, I soldered my gamecube and hooked up everything. I flashed the bios and now when put on my gamecube, Nothing pops up! I tried putting an original disk in it, but it doesnt spin.

    Disc does not spin, nothing shows on the screen. HHHHEEEEEEEEEELLLLLLLLLLPPPPPPPP PLEASE

    IM DESPERITE
     
    Sumone157, Nov 15, 2005
    #1
  2. wiseblood

    wiseblood Member

    Joined:
    Mar 9, 2003
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    11
    Make sure all your soldering points are still good, check over every one. Also, if any wire is pinched or squeezed when you put the console back together, that would also cause the symptoms you describe.
    Just re-check everything carefully, and put it back together carefully.
     
    wiseblood, Nov 15, 2005
    #2
  3. Sumone157

    Sumone157 Regular member

    Joined:
    Feb 5, 2005
    Messages:
    333
    Likes Received:
    0
    Trophy Points:
    26
    does anyone know which soldering point is causing this?
     
    Sumone157, Nov 15, 2005
    #3
  4. wiseblood

    wiseblood Member

    Joined:
    Mar 9, 2003
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    11
    the 5volt spot would cause the disk not to spin.
     
    wiseblood, Nov 15, 2005
    #4
  5. Sumone157

    Sumone157 Regular member

    Joined:
    Feb 5, 2005
    Messages:
    333
    Likes Received:
    0
    Trophy Points:
    26
    Thank you wiseblood, this morning i got the Original boot screen to apper. Now i have to go and seach the alternet 5v point, BTW i have gv rev C it that means anything.
     
    Sumone157, Nov 16, 2005
    #5

Share This Page