Ok i had error 21 and i tried to hotswap but it wasnt working. So i put my xbox back together [bold](All the cords and everthing are in)[/bold] and know i get error 7. Is there any way to fix this?
7 - kernel - HDD timeout Most of the times, the IDE cable is not properly connected when you see this error. Please reattach the ide cable. Not only to the harddisk drive but also to the dvd drive. ALso try to reconnect the ide cable to the motherboard. Press pretty hard so it goes all the way in. Make sure it is seated straight and proper in the drives and the motherboard. If you still have an error 7. Try another ide cable. If that won't work try another harddisk. If there is still no go, try to set the jumpers on the rearside of the harddisk drive. Set it to master or cable select.
im not sure if this will work with error 7..but try to disconect the back of the dvd drive [bold]**while the xbox is off**[/bold]then plug it back in then it should give u error 11..which is the same as error 10 10 - kernel - DVD timeout Actually its almost the same as error 6/7/8. But also make sure the yellow cables are properly connected to the motherboard and the dvd drive. 1. Make sure ide cables are connected good. 2. Make sure the yellow cables are good and properly connected. 3. Still no succes? Try another dvd drive of which you are sure it is working. 11 - kernel - No DVD Found Same as #10 So read up please!
alright i used a new IDE cable and everything is in. But now when i turn it on it like reboots 3 times then it blinks Red and Green. Help Please?
Hmm... that is fragging. You might have to look in the hardware boot discussion forum for help on that.
