I have flashed my xbox 360 with a hitachi 47 drive, with iextreme 1.4 software. Everything went fine it said 100% complete. I downloaded the wanted game torrent and used both imgburn and clonecd to copy it to a RW+R DL dvd. Neither worked. They both complete the copy and say everything is ok but when I put it in the flashed xbox it shows up as a dvd and when I click on it, it goes to the white xbox screen and just stays there. Is there something I am missing or doing wrong? Ive been working on this for a few days now and any help you can give me at all would be great. Thank you!
Oh ok. The only problem is that whenever I try to load that firmware to my 360 through command prompt it opens up and then disappears quick. If I open command prompt and then drag the file or type in FLASH22S it tells me that command is not supported. Any Ideas. It could be the old computer I am using haha.
I don't think you can use dos with an hitachi. I'm not sure as I haven't done many hitachis. Use firmware toolbox 4.8. Be sure to flash it back to original before flashing 1.51. I'm sure there is a tut around here somewhere for it....
ok so I downloaded the maximum firmware toolbox 4.8 and did all the steps and after i do the check sum i get: The data dumped does not match its own checksum. Do you want to accept anyways. I have tried 10 times and keep getting the same message
I'm pretty sure with Hitachi's you have to restore OFW first then flash the CFW. Someone correct me if I'm wrong. It does not have to be your OFW. It can be a generic version
i did my hitachi in windows using firmware toolbox. You are gonna need a copy of the original firmware and the ixtreme151 firmware.
original firmware with or without your serial key, as long as you know your key. use jungle flasher it will do most of it for you.
