right ok i am a noobe to this kinda scene and i have read through loads of guides when installing the X3 CE. rigt my first question is i look at the first diagram and i have notcied you have to use GREEN: LADO YELLOW:LAD1 RED:LAD2 BLUE LAD3.Now where do these wires come from, do they come from the wire install adpater, do i have to cut them off. or do i have to get seprate wires for this job. also when instaling these wires to the lpc to i have to have the pin installed and then solder the the wires to the specific pins are in. am i right lol. please dont have a go at me or nothing i just dont want to muck up my xbox. thanks people
actually dont worry now friend, btw i have installed the chip i got it 2 work well, the blue lights came up so i guess i soldered the 5v wire very good. anyway i noticed that i my hdd/lanwere not showing up on the outside switch on the front of the xbox, so i went and checked all 3 wires the d0 was in the rebuild very well, the other 2 were not properly connected so i added solder only a little to make connection. put it all back together then it didnt turn on, so i looked and took the chip off the pins and noticed one was pushed down a bit. so i took just the chip out and put it all back together again and then it worked. so do u think im right about the pin moving out of place, wil i be able to level it up with the other pins and solder it in to place? its been along day lol
