Install Qoob chip and can't get it to load up now.

Discussion in 'Nintendo Gamecube - General discussion' started by madman_31, Apr 21, 2005.

  1. madman_31

    madman_31 Member

    Joined:
    Oct 24, 2004
    Messages:
    68
    Likes Received:
    0
    Trophy Points:
    16
    I installed a Qoob chip they way it's ment to be and It seems its not getting power to where its ment to be getting power.

    Where the 5V wire goes I had alot of troble getting it on because it would not stick to it and I started skaching that point so bear metal shows. You just skacking the top copper layer off a bit. (I think I stuff somethng up on GameCube console motherboard were the 5V wire goes.)

    What do you's think I did because I have no qlue?
     
    madman_31, Apr 21, 2005
    #1
  2. madman_31

    madman_31 Member

    Joined:
    Oct 24, 2004
    Messages:
    68
    Likes Received:
    0
    Trophy Points:
    16
    The chip fine because I loaded a BIOS to it but my Gamecube DVD drive is not getting any power.

    Does any no know whats wrong with my gamecube?
     
    madman_31, Apr 21, 2005
    #2
  3. madman_31

    madman_31 Member

    Joined:
    Oct 24, 2004
    Messages:
    68
    Likes Received:
    0
    Trophy Points:
    16
    Unpluged all the wires for the chip from the GameCube and it works fine now. I think I will pay someone I know to get it installed.
     
    madman_31, Apr 22, 2005
    #3
  4. darealone

    darealone Member

    Joined:
    Apr 6, 2005
    Messages:
    24
    Likes Received:
    0
    Trophy Points:
    11
    sounds like trouble

    i can only hope that you can fix it coz when i get my chip next week i might need help also
     
    darealone, Apr 27, 2005
    #4

Share This Page