Hey guys Im haveing real issues updateing my Xenium SP.ICE on my 1.6 xbox. All im getting after following directions from the offical Guide to upgradeing to 2.3.0 from 2.0.1 im left with a Black screen with my xbox light blinking amber. I figured, "hey it may be doing somthing, Ill leave it to do its thing", 9 hours Later (after work) the damn thing is still not doing anything, so i reset it and it boots back up in the old 2.0.1 Xenium OS menu :/ Any advice? (edited for spelling mistakes LOL) Oh and 1 other problem. i dont have a clue on what is needed to be done to install evox dashbord, if anyone can give me some step by step advice id be greatfull thanks peeps
Hey guys, quick update on my situation i managed to get the custom M8 bios working and its up and running with EVOx 2.6 thanks anyway
How did you even get the chip installed. The wires wont fit in those little holes. I can get them to touch good enough with the template, and all five lights go on, and one goes out after inserting the chip. The chip lites up too. All the box does is flash red for couple seconds and powers itself off.
sometimes the xbox comes with a coat of thin lacker on the points, try to carefully scratch the lacker off the point itself. The xbox resets itself over and over with the red light if you fit it to the socket wrong, without pictures i cant realy tell you what your doing wrong
i know there is a litlle lag in this response but, to remove laquer the safest way use a q-tip and fingernail polish remover you dont run the risk of screwing it up that way and the remover evaporates
