jungle flasher prolbems!!

ok so i startd flashing my benq drive with jungle flasher but when i start out it says no drive detected in the drive properties....what do i do to fix it?

 

Have you installed the PortIO32 drivers?

 

better question, have you read any of the tutorials first?

 

yeah i read them, i did what they said also,
i just needed to knwo if it was my fault it wasnt reading the drive, or if it was the flashers fault.....im kinda new to flashing and just need some help

 

I tried to do my benq with jungle flasher and it wouldn't detect my drive. I used the old dos method, dben, fben. worked fine. I actually even had c4eva helping me and we couldn't get it to detect it.

 

Yeah I was having the same problem and basically I just had to play with turning the drive on and off and starting jungleflasher and closing it.

I think what I ended up doing was turning off the drive, and closing JF, and then turn on the drive and open JF, and you really only get one chance to play with it, and then I would loose it and have to do the same thing again.

Hard to explain but just did a lot of playing around.

 

You turn your drive on and then open JF.

You might also have to check each port from the I/O Port drop down menu to get it recognized.

The new JF is GREAT btw, IMO.