ok, whoever's reading thank you... i have a xbox v 1.0 , x2lite plus, and the x2lite programmer When i try to flash the chip with the programmer, it results in frags... the only time it doesnt frag is when i flash it with the ozxchip bios or the clean linux bios but i tried it with X2 4977, and EvoX M7, and some others.. all.. fragg but when i program it i always get the same error, regardless of what bios i use... When i use the "x2cable i" command to get the info it comes up as... Manufacturer Code: 01h Device Code: 91h Security Bit: 00000000 not the 01 D5h im supposed to get.. -The programer is directly connected to my printer port -the chip is on enable, unprotect, bank 1 or 2 (same) -Powered by USB I can, erase the chip (x2cable e) or read the bios from the chip (x2cable r) and theres no problem at all however when i try to write, it goes all the way to 100% in around 800s then it says: Writing...Done. Time taken = 810s. Error at location 00000h! then i install the chip and, once again, fragville... unless its a clean bios then i flashed it with the only bios that works, the cromwell, and i made a cdrw with the x2 4977 bios on it.. i tried flashing it through the CD, after it erased, flashed, and verified..it shut down.. then..what happen?? FRAG! I spent like $80 for all this, someone pleasee help, ill greatly appreciate any help to get me through this! and tell me if im not making this clear enough or left out any details.. -MaNNu
Its possible you could have a bad download of the bios, I was helping someone else on here that ended up being their problem, but more than 1 bios unlikely. Just to make sure, you're extracting the files from the .rar file, creating a 1 mb file from the .bin file and then flashing that correct?
thats exactly what im doing, i tried downloading it several times as well, from different places. then i made a 1 mb with x2bm and flash it.
why isnt anyone helping mee!!!! do you think my chip is defective? should i contact the-console-corner and ask to replace the chip?
Sorry I cant be of any help, I would contact console-corner though. The only info I found on the web where it mentioned frag was a bad bios.
I was under the impression that the x2.2 lite+ came preflashed. In order to install Evox does it need to be reflash or can you simply load the evox ISO cd as is? If the chip does need reflased I pray it is not too difficult...
i thitnk my chip is defective because no one else seems to be having similar problems, and the programmer doesnt detect a bad bios, only the chip... modnoob, it comes flashed with cromwell clean bios, from there you have to flash it with a good bios (that allows evox to run) such at x2 4977
