hi guys im trying to make a car charger and and a data cable for the motorola v3 razr. i have a nokia LCH-9 car charger but i dont have that phone any more so this is junk parts that i am trying to take the connector off of the v3 razr head set and put it on this car charger so that i can have a car charger. because i dont use the headset very much but i am always needing a car charger. so any ways i cut off the nokia connector and now i have three wires coming from the car charger theres a ( Red, Black, And White ) wire. now when i cut the connector from the v3 head set there is a ( green, white, red, and black ) wire. how do i connect these togeather to make my v3 phone able to charge via car cigarette lighter port? also im trying to make a usb data cable. i have a usb cord and a connector for the v3 razr phone. the connector for the v3 razor phone has the same wires as before. ( red, white, green, and black ). im not sure whats in the usb cable because i dont want to cut it open unless i know for sure its possible to create the data cable with the resources that i have. if you have any ideas or questions just let me know please. thanks to everyone in adavance .
I would not run the risk or screwing something up but connecting the wrong wire to save a few buck on a 200$ phone, so why not just buy a data cable and a charger off ebay for cheap. http://cgi.ebay.ca/MOTOROLA-RAZR-V3...2QQihZ013QQcategoryZ35209QQrdZ1QQcmdZViewItem http://cgi.ebay.ca/CAR-CHARGER-MOTO...QQihZ013QQcategoryZ108599QQrdZ1QQcmdZViewItem Just a suggestion
@gamer17 - that sig is one of the biggest i've seen for ages, that's almost the size of an A4 page; let's see it shrunk right down - allowed size is in the Forum Rules in my sig
